Each headlamp is attached by retainers
with
round
plastic knobs. Remove the retainers by turning
in
a
counter-clockwise direction.
Lift the headlamp away from the car. Pull the bulb
socket straight out.
I.
I
Turn the bulb socket
1/4
turn counter-clockwise,
while pressing
it
firmly.
C
Remove
the
wire connector from the bulb by lifting the
lock tab and pulling
it
away from the plastic base.
To
install, attach the wire connector
(A)
to the plastic
base making sure the lock tab
(B)
is over the lock
(C).
Install the bulb by putting the small tab
(D)
into
the
small notch
in
the lamp
(E).
Turn the bulb socket
1/4
turn
clockwise to lock
it
into
place.
When reinstalling the headlamp assembly into the
headlamp mounting panel make sure the tab
is
properly
engaged in the panel slot.
237
To Next Page
Loading...
