yellowblue
6-39
5. Replace the bulb and reverse the steps to install the
new bulb assembly.
Rear Turn Signals
1. Open the trunk. Turn the screw located just inside of
the trunk counterclockwise and remove.
2. Pull the carpet away from the rear area to access the
turn signal bulb assembly.
3. Turn the bulb socket one
-quarter turn
counterclockwise, while pressing it firmly.
4. Pull the bulb socket straight out of the assembly.
5. Remove the old bulb by pulling it straight out.
6. Replace with a new bulb by pushing the bulb straight
into the socket until the bulb clicks into place.
7. Turn the bulb socket one-quarter turn into the
assembly to lock it back into place.
8. Reverse Steps 1 through 3 to reinstall the
bulb assembly.
To Next Page
Loading...
Need help?
General
