yellowblue
1-4
Memory Seat and Mirrors (Option)
The controls for the memory seat and mirrors are located
on the driver’s door panel, and are used to program and
recall previous settings that have been stored.
Adjust the driver’s seat (including the lumbar
adjustments) and both outside mirrors to the position
you would like for driving. Then press and hold memory
button 1 for five seconds. A double beep will sound
when the memory is set.
To set the seat and mirror positions for a second driver,
follow the previous steps, but press button 2 instead.
When your vehicle is in PARK (P) and a memory button
is pressed, a single beep will sound through the audio
system and the memory position will be recalled.
You can also store an exit position for each driver. The
exit position is programmed by moving the seat to the
desired exit position and then holding the exit button for
five seconds. The exit position set will be for the most
recently selected driving position (1 or 2).
The exit position will be recalled when the exit button is
pressed and will correspond to the driving position that
was recalled last.
Note that selecting a new position with the memory button
will change all other personal choice settings that you have
previously programmed also. See “Personal Choice
Programming” in the Index for further information.
Memory recall will only work when the automatic
transaxle is in PARK (P).
To Next Page
Loading...
Need help?
General
