3-3
Mode Knob
The right knob has several settings to control the
direction of airflow. To access the various modes
available, turn the mode knob to the desired mode.
MAX (Maximum Air Conditioning): This setting
recirculates much of the air inside your vehicle and
sends it through the instrument panel outlets. The air
conditioning compressor will run automatically in this
setting unless the outside temperature is below 40
_
F
(4
_
C). (Even when the compressor is running, you can
control the temperature.)
VENT (Ventilation): This setting brings in outside air
and directs it through the instrument panel outlets.
BI
-LEV (Bi-Level): This setting brings in outside air
and directs it two ways. Half of the air is directed
through the instrument panel outlets. Most of the
remaining air is directed through the floor ducts and a
little to the defrost and side window vents.
HTR (Heater): This setting sends most of the air
through the ducts near the floor. The rest comes out of
the defroster and side window vents.
BLEND: This setting allows half of the air to go to the
floor ducts and half to the defroster and side window
vents. The air conditioning compressor will run
automatically in this setting unless the outside
temperature is below 40
_
F (4
_
C). (Even when the
compressor is running, you can control the temperature.)
DEF (Defrost): This setting directs most of the air
through the defroster and side window vents. Some of
the air goes to the floor ducts and the side window vents.
The air conditioning compressor will run automatically
in this setting unless the outside temperature is below
40
_
F (4
_
C). (Even when the compressor is running,
you can control the temperature.)
Mode Button
A/C (Air Conditioning): Press this button to turn
the air conditioning on and off. The system will cool and
dehumidify the air inside the vehicle when the A/C light
is on.
To Next Page
Loading...
Need help?
General
