7-28 Infotainment System
Once connected, the person called
will be heard through the audio
speakers.
Using the “Redial” Command
1. Press
b / g . The system
responds “Ready,” followed by
a tone.
2. After the tone, say “Redial.” The
system dials the last number
called from the connected cell
phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
.
Press b / g to answer the call.
.
Press $ / i to ignore a call.
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
.
Press b / g to answer an
incoming call when another call
is active. The original call is
placed on hold.
.
Press b / g again to return to
the original call.
.
To ignore the incoming call, no
action is required.
.
Press $ / i to disconnect the
current call and switch to the call
on hold.
Three-Way Calling
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press
b / g.
2. Say “Three-way call.”
3. Use the dial or call command to
dial the number of the third party
to be called.
4. Once the call is connected,
press
b / g to link all callers
together.
Ending a Call
Press $ / i to end a call.
Muting a Call
During a call, all sounds from inside
the vehicle can be muted so that the
person on the other end of the call
cannot hear them.
To mute a call, press
b / g , and
then say “Mute Call.”
To cancel mute, press
b / g , and
then say “Un-mute Call.”
Transferring a Call
Audio can be transferred between
the Bluetooth system and the cell
phone.
To Next Page
Loading...
