Buick Envista 2025 - Page 160

Buick Envista Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-18181221) - 2025
Driving and Operating 159
*
: Press to disengage cruise control without
erasing the set speed from memory.
Setting Cruise Control
If cruise control is on but is not engaged, the
thumbwheel could get pressed to SET− or RES+
and engage cruise control when not desired.
Keep cruise control off when it is not being
used. Press 5 to turn off cruise control.
To select the cruise speed and engage
cruise control:
1.
Press 5.
2. Accelerate to the desired cruise speed.
3. Briefly press and release the thumbwheel
down to SET− .
4. Remove your foot from the
accelerator pedal.
When cruise control has been engaged, the
cruise control light displays green in the
instrument cluster.
Resuming aSet Speed
I
f cruise control is engaged and then the brakes
are applied or * is pressed, cruise control is
disengaged without erasing the set speed from
memory.
Once the vehicle reaches about 40 km/h (25
mph) or more, briefly press the thumbwheel
up to RES+ and release. The vehicle returns to
the previous set cruise speed.
Increasing Speed While Using Cruise Control
If the cruise control is currently engaged, do
one of the following:
•
Press and hold the thumbwheel up to RES+
until the vehicle accelerates to the desired
speed, then release it.
•
To increase the vehicle speed in small
increments, briefly press and release the
thumbwheel up to RES+. For each press, the
vehicle speed increases by about 1 km/h (1
mph).
The speedometer reading is displayed using
either English or metric units. See Instrument
Cluster 384. The increment value used
depends on the units displayed.
Reducing Speed While Using Cruise Control
I
f the cruise control is currently engaged, do
one of the following:
•
Press and hold the thumbwheel down to
SET− until the desired lower speed is
reached, then release it.
•
To decrease the vehicle speed in small
increments, briefly press and release the
thumbwheel down to SET−. For each press,
the vehicle speed decreases by about 1 km/
h (1 mph).
Passing Another Vehicle While Using
Cruise Control
To pass another vehicle while cruise control is
engaged, use the accelerator pedal to increase
the vehicle speed. When you remove your foot
from the accelerator pedal, the vehicle will slow
down to the previously set cruise speed. While
pressing the accelerator pedal or shortly
following the release to override cruise
control, briefly pressing the thumbwheel down
to SET− will result in the cruise speed being set
to the current vehicle speed.