Buick Envista 2025 - Park Brake and P (Park) Mechanism Check; Wiper Blade Replacement

Buick Envista Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-18181221) - 2025
Vehicle Care 205
Park Brake and P(Park)
M
echanism Check
{ W
arning
When you are doing this check, the vehicle
c
ould begin to move. You or others could
be injured and property could be damaged.
Make sure there is room in front of the
vehicle in case it begins to roll. Be ready to
apply the regular brake at once should the
vehicle begin to move.
Park o
n a fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular
brake, set the parking brake.
•
To check the parking brake's holding
ability: With the engine running and the
transmission in N (Neutral), slowly remove
foot pressure from the regular brake pedal.
Do this until the vehicle is held by the
parking brake only.
•
To check the P (Park) mechanism's holding
ability: With the engine running, shift to
P (Park). Then release the parking brake
followed by the regular brake.
Contact your dealer if service is required.
Wiper Blade Replacement
Caution
Allowing the wiper arm to touch the
windshield when no wiper blade is installed
could damage the windshield. Any damage
that occurs would not be covered by the
vehicle warranty. Do not allow the wiper
arm to touch the windshield.
Caution
Damage may occur if the wiper blades are
n
ot in contact with the windshield before
turning on the wiper system.
Windshield wiper blades should be replaced
p
eriodically. See Maintenance Schedule 3254.
Replacement blades come in different types
and are removed in different ways. For proper
type and length, see your dealer.
To replace the wiper blades:
1. Lift the wiper arm from the windshield until
no further movement is possible.
2. Press the release button on the top side of
t
he wiper and pull the wiper blade out of the
end of the wiper arm.
3. Install the wiper blade connector by sliding
into the end of the wiper arm until the
button on the wiper blade clicks into place
with the wiper arm.
4. Place the wiper arm with the wiper blade in
place back on the windshield.