THEFTLOCK’”
Your system has this feature
if
it shows “Theftlock” on
its face. THEFTLOCK” is a theft-deterrent feature that
can be used or ignored.
If
you ignore it, your system will
play normally.
If
you use it, your system can’t be turned
on if it is stolen because it locks anytime battery power
‘
is removed. To unlock it, a code must be entered.
These instructions will tell you how to enter a code into
your system. They
also
tell you how to unlock the
system with your code and how to shut
off
the
THEFTLOCK
TM
system.
Entering
a
Code
1.
Write down any number from
000
to
1999.
This
is
your code.
2.
Turn
the
ignition to ACCESSORY or RUN.
3.
Turn the radio
off.
4.
Press
buttons
1
and
4
at $he same
he
and holq until
“-
-
-”
shows on the display.
You now have only
15
seconds between each of the
following steps.
$
5.
Press
MIN
and
“000”
will appear on the display.
6.
Press
MIN
again and
-,
hold until the last two digits
of
your code appear.
:
7.
Press and hold
‘HRS
until the first digit or digits
of
your code appear.
8.
Press
AM
FM
after you make
sure
the code matches
the one you wrote down.
“rEP”
will appear on the
display, meadng you should repeat Steps
5
through
7.
should appear on the display, meaning your system is
secured.
If
your ignition is
off,
“Theftlock” will flash
in the display.
9.
After you repeat the steps, press
AM
FM.
SEC
Store the paper with your code written on it
in
a safe place.
3-16
To Next Page
Loading...
