Then, without shutting
off
the engine, follow these steps:
r
1.
Flip
the
handle up and
then pull
out
the dipstick
and wipe it with a clean
rag or paper towel.
2.
Push it back in all the way, wait three seconds and
then pull
it
back out again.
L
3.
Check both sides of the dipstick, and read the lower
level. The fluid level must be in the COLD area for a
cold check or in the HOT area
or
cross-hatched area
for
a hot check.
4.
If the fluid level is in the acceptable range, push the
dipstick back
in
all the way; then flip the handle
down
to
lock the dipstick
in
place.
6-15
To Next Page
Loading...
