To
replace the batteries:
1.
If
your transmitter has a screw, remove the screw
Automatic Pull-Down Feature
(ODtion)
from
the
back cover. If there is no screw, carefully
pry
off
the cover by inserting a dime (or similar
object) in the slot between the covers and twisting.
\I
If you have this feature, it pulls the trunk lid closed.
This
allows you to gently push the trunk lid down and the
:
I
pull-down feature then secures it completely.
I
2.
Lxft
off
the front cover, bottom half first.
3.
’
Remove and replace the batteries. Put them in as
indicated by the directions under the batteries.
4.
Replace the front cover. Make sure the cover is on
tightly,
so
water won’t get in. Replace the screw
in
the back cover, if there is one.
If
there is no screw,
snap together.
5.
Check the operation of the transmitter.
~~ ~ ~ ~~ ~~~~ ~
NOTICE:
Do
not slam your trunk lid down if you have the
pull-down feature.
If
you
do,
you may damage
the pull-down system.
1
2-7
To Next Page
Loading...
