RECALL:
Press this button briefly to recall the station
being played or the clock display.
To
change what is
normally shown on the display (station or time), press
the button until you see the display you want, then hold
the button until the display flashes. If you press the
button when the ignition is
off,
the clock will show for a
few seconds.
Finding a
Station
AM-FM:
Press this button to select AM, FM1 or FM2.
The display shows your selection.
TUNE:
Press the up or down mow to choose radio
stations.
SEEK:
Press the up or down mows to go to the
next higher or lower station. The sound
will
be muted
while
seeking.
SCAN:
Press one of the SEEK arrows for two seconds
and SCAN will appear on the display. Use
SCAN
to
listen to stations for a few seconds. The radio will go to
a station, stop for a few seconds, then go on to the next
station. Press one of the SEEK arrows again to stop
scanning. The sound will be muted while scanning.
PUSHBUTTONS:
The six numbered pushbuttons let
you return to your favorite stations. You can set up to
18 stations (six AM, six FM1 and six
FM2).
1.
2.
3.
4.
5.
Press
AM-FM
to select the band.
Find the station you want by using TUNE or SEEK.
Press TONE to select the setting you prefer.
Press and hold one of the six numbered buttons.
The sound will mute. When it returns, release the
button. Whenever you press that numbered button,
the station you set will return and the TONE you
selected will be automatically selected for that
button.
P SCAN:
Press this button to listen to each of your
preset stations for a few seconds.
The
radio will go to
the first preset station, stop for a few seconds, then go
on to the next preset station. Press
P
SCAN again to stop
scanning.
If
a preset station has weak reception, the
radio will not stop at the preset station.
AUTO
PRESET
Press this button and the system will
seek and set the 12 strongest
FM
or the
6
strongest
AM
stations on your preset buttons. To return to the stations
you manually set, press AUTO PRESET again.
3-13
To Next Page
Loading...
