On the station wagon, slide the back of the jack base
into the retainer in the storage area. Put the wing bolt
through the hole in the wrench, then through the hole in
the jack. Tighten the wing bolt into the fastener in the
storage area. Put the flat or spare into the storage well
with the valve stem pointed toward you. Insert the hook
end of the bolt through the wheel and into the retainer in
the well. Put the disc onto the bolt, then tighten the wing
nut on the bolt. Attach the tire lift strap
to
its retainer.
To replace the
trim
cover, put the lower edge of the
cover into the floor track. Slide the cover toward the
front of the vehicle, making sure the front tab goes
behind the edge. Insert the rear edge of the cover into
the track, adjusting it to fit over the weatherstrip. Snap
the front edge
of
the cover into place. Align the slotted
button at the rear edge of the cover and
turn
it to secure
the trim panel.
On
the sedan, replace the jack, flat or spare tire, and
wheel wrench and tighten the wing nut on the screw.
1.
Wing Nut
2.
Wrench
3.
Compact Spare
4.
Full-Size Spare or Flat Tire
5.
Jack Cover (If Provided)
6.
Jack
7.
Screw (Hold-down)
8.
Floor Bracket
To Next Page
Loading...
