Then, without shutting
off
the engine, follow these steps:
1.
Flip the handle up and then pull out the dipstick and
wipe it with
a
clean rag or paper towel.
3.
Check both sides of the dipstick, and read the lower
level. The fluid level
must
be in the
COLD
area for
a
cold check or in the
HOT
area or cross-hatched area
for a hot check.
4.
If the fluid level is in the acceptable range, push the
dipstick back in
all
the
way; then flip the handle
down
to
lock the dipstick in place.
2.
Push
it back
in
all the way, wait three seconds and
then pull
it
back out again.
To Next Page