Cleaning
the
Inside
of
Your
Buick
Use a vacuum cleaner often to get rid of dust and loose
dirt. Wipe vinyl or leather with
a
clean, damp cloth.
Your Buick dealer has two
GM
cleaners, a solvent-type
spot lifter and a foam-type powdered cleaner. They will
clean normal spots and stains very well. Do not use
them on vinyl or leather.
Here are some cleaning tips:
0
0
0
0
0
Always read the instructions on the cleaner label.
Clean up stains as soon as you can
--
before they set.
Use a clean cloth or sponge, and change to a
clean area often.
A
soft
brush may be used if stains
are
stubborn.
Use solvent-type cleaners in a well-ventilated area
only. If you use them, don’t saturate the stained area.
If
a ring forms after spot cleaning, clean the entire
area immediately or it will set.
Using Foam-Qpe
Cleaner on Fak
*c
1.
Vacuum and brush the area to remove any loose
2.
Always clean
a
whole trim panel or section. Mask
3.
Mix
Multi-Purpose Powdered Cleaner following
dirt.
surrounding trim along stitch or welt lines.
the directions on the container label.
4.
Use suds only and apply with a clean sponge.
5.
Don’t saturate the material.
6.
Don’t rub it roughly.
7.
As soon as you’ve cleaned the section, use
a
sponge
to
remove the suds.
8.
Rinse the section with a clean, wet sponge.
9.
Wipe
off
what’s left with a slightly damp paper
towel or cloth.
10.
Then dry it immediately with a blow dryer.
11.
Wipe with a clean cloth.
6-46
To Next Page
Loading...
