4.
Push the latch plate into the buckle until it clicks.
Make sure the release button on the buckle is Positioned
so
you would be able to unbuckle the safety blelt quickly
if you ever had to.
If
the belt stops before it reaches the buckle, tilt the latch
plate and keep pulling until you can buckle the belt.
Pull up on the latch plate to make sure it is secure.
If
the belt isn’t long enough, see “Safety Belt Extender”
at the end of this section.
1-14
5.
To
make the lap part tight, pull down on the buckle
end of the belt as you pull up on
the
shoulder belt.
To Next Page
Loading...
