Turn Signal and Lane Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal
a
turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
An arrow on the instrument
panel will flash in the
To
signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold
it
there until you
complete your lane change. The lever will return by
itself when you release
it.
As
you signal a turn or a lane change,
if
the arrows don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal
a
turn, check for burned-out bulbs and check the
fuse (see “Fuses and Circuit Breakers” in the Index).
If you have a trailer towing option with added wiring for
the trailer lamps, a different turn signal flasher is used.
With this flasher installed, the signal indicator will flash
even if a turn signal bulb is burned out. Check the front
and rear turn signal lamps regularly to make sure they
are
working.
A chime will sound if your turn signal remains on after
having driven
1/2
mile
(0.8
km),
to remind you to turn
off your signal.
Headlamp Highbow Beam
Changer
To change the headlamps
from low beam to high or
high to low, pull the turn
signal lever all the way
toward you. Then release
it.
When the high beams are
on,
this light on the
instrument panel will also
be on.
To Next Page
Loading...
