Infotainment System 7-29
If an unwanted number is
recognized by the system, say
“Clear” at any time to clear the last
number.
To hear all o f the numbers
recognized by the system, say
“Verify” at any time.
1. Press
b / g.Thesystem
responds “Ready,” followed by
atone.
2. Say “Digit Dial.”
3. Say each digit, one at a time,
that you want to dial. After each
digit is entered, the system
repeats back the digit it heard
followed by a tone. After the last
digit has been entered,
say “Dial.”
Once connected, the person called
will be heard through the audio
speakers.
Using the “Re-dial” Command
1. Press
b / g.Thesystem
responds “Ready,” followed by
atone.
2. After the tone, say “Re-dial.” The
system dials the last number
called from the connected cell
phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
.
Press b / g to answer the call.
.
Press $ / i to ignore a call.
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
.
Press b / g to answer an
incoming call when another call
is active. The original call is
placed on hold.
.
Press b / g again to return to
the original call.
.
To ignore the i n c o m i n g c a l l , no
action is required.
.
Press $ / i to disconnect the
current call and switch to the call
on hold.
Three-Way Calling
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press
b / g.
2. Say “Three-way call.”
3. Use the dial or call command to
dial the number of the third party
to be called.
4. Once the call is connected,
press
b / g to link all callers
together.
Ending a Call
Press $ / i to end a call.
To Next Page
Loading...
