Need help?Do you have a question about the Building 36 B36-T10 and is the answer not in the manual?
General| Brand | Building 36 |
|---|---|
| Model | B36-T10 |
| Category | Thermostat |
| Language | English |
Always turn off power at the breaker before installation or servicing and avoid shorting terminals to prevent damage.
Follow local codes. Power thermostat with 4AA batteries or 24 VAC. Avoid high amperage loads on relays.
Test HVAC system before installation and disconnect power at circuit breaker before removal.
Verify system voltage is 24 VAC; do not install on high voltage (120/240V) systems.
Install batteries with correct polarity. Replace promptly when low battery is indicated.
Put thermostat in OFF mode, press gateway inclusion, then press and hold DOWN button on thermostat.
Configure system parameters like heat pump type, stages, and advanced settings via customer account.
Firmly press thermostat body onto back plate, ensuring pins align correctly to avoid damage.
Set to HEAT mode, raise setpoint, wait 10 seconds, verify heating, then set desired temperature.
Set to COOL mode, lower setpoint, wait 10 seconds, verify cooling, then set desired temperature.
Rapid battery drain may indicate constant Z-Wave repeater activity when C-wire is connected.
System has a minimum temperature difference setting and compressor delay to protect equipment.
To Next Page
