Need help?Do you have a question about the Bull Escala and is the answer not in the manual?
Details the capabilities, standards compliance, and performance of the ISA Internal Modem.
Describes the components included with the ISA Internal Modem hardware and software.
Lists the software components (OPPs) for the ISA Internal Modem and installation method.
Details the physical parts of the ISA Internal Modem, including the modem board and cables.
Specifies the operating system environment for the ISA Internal Modem adapter.
States that no specific prerequisite software is required for the ISA Internal Modem package.
Explains how to manage the ISA Internal Modem using the SMIT interface and TTY configuration.
Instructions for verifying the contents of the ISA Internal Modem delivery package.
Details the two components of the ISA Internal Modem delivery and their identifiers.
Explains how modem types are identified by labels based on the country of destination.
Guide on setting jumpers for COM/IRQ configuration and physically installing the modem.
Instructions for connecting the modem to the telephone line.
Specific connection steps for the USA option modem, including dual line jacks.
Steps for connecting the telephone line to modems for countries other than the USA.
Method to verify if the ISA Internal Modem software has been pre-loaded using SMIT.
Details on configuring the modem adapter's bus I/O address and interrupt level using SMIT.
Guide for configuring the TTY device for the modem when not used by RSF, using SMIT.
Command to check the current configuration status of the modem device.
Procedures for removing the ISA Internal Modem software using the SMIT interface.
How to verify the operational status of the modem, especially when used with RSF.
Steps to diagnose and resolve issues with the modem, including cable checks and diagnostics.
Lists detailed technical specifications of the ISA Internal Modem, including data rates and compatibility.
To Next Page
General