Bulldog Scrubbers BD20 User Manual (English)

Questions and Answers:

C
Charles TaylorJul 31, 2025
How to troubleshoot poor water pick up in Bulldog Scrubbers Scrubber?
- M
  Martha MasonJul 31, 2025
  If your Bulldog Scrubbers Scrubber isn't picking up water effectively, several factors could be the cause. Check for worn or torn squeegee blades and rotate or replace them if necessary. Ensure the recovery tank isn't full; empty it if it is. Inspect the recovery tank drain hose and lid gasket for leaks; secure the cap or replace the hose, and properly replace the lid gasket. Also, check for debris caught in the squeegee and clean it. Adjust the solution control lever if you're using too much solution. Finally, inspect the recovery hose for disconnections or damage, reconnecting or replacing as needed.
J
James NicholsAug 5, 2025
Why is the Bulldog Scrubbers Scrubber having poor scrubbing performance?
- K
  Kristen CarterAug 5, 2025
  If your Bulldog Scrubbers Scrubber isn't scrubbing well, there might be several reasons: * The brush or pad could be worn and needs replacement. * Debris might be caught on the scrub brush, requiring removal. * You might be moving the machine too fast, so slow down. * The solution flow setting might be too low, so adjust it. * The battery charge might be low, so recharge the batteries. * The retaining ring on the brush motor shaft might not be in the groove, so remove the brush hub assembly and slide the ring into the groove.
B
Brian BeanAug 10, 2025
What to do if Bulldog Scrubbers BD20 Scrubber does not operate?
- B
  Brian WilliamsAug 10, 2025
  If your Bulldog Scrubbers Scrubber isn't operating, start by checking the control power circuit breaker and reset it if it's tripped. Also, ensure the batteries are adequately charged; recharge them if they're low. If the battery charger is operating, unplug it once the charge is complete.
B
Benjamin ScottAug 15, 2025
Why vacuum motor does not turn on in Bulldog Scrubbers BD20 Scrubber?
- S
  Susan SandovalAug 15, 2025
  If the vacuum motor on your Bulldog Scrubbers Scrubber isn't turning on, there are several potential causes. First, check if the recovery tank is full and empty it if necessary. Excessive foam in the recovery tank can also be a problem; in that case, empty the tank and consider using less chemical or a defoaming agent. Other possible causes include worn carbon brushes (replace them), a disconnected vacuum switch (connect the wiring), a tripped vacuum motor circuit breaker (reset it), a broken vacuum limit switch (replace the switch by the squeegee lift lever), or the squeegee being in the raised position (lower the squeegee).
A
alanlyonsAug 20, 2025
How to fix inadequate solution flow in Bulldog Scrubbers BD20?
- A
  Anthony WilliamsAug 21, 2025
  If you're experiencing inadequate solution flow or no solution reaching the floor with your Bulldog Scrubbers Scrubber, start by checking if the solution tank is empty and fill it if needed. Then, inspect the solution lines, valves, and filter for clogs; flush the lines and clean the solution filter. Finally, ensure the solution lever is not in the down position; move it up.