Magnum Biometric Top Load Quick Vault (BD4055B)
Instruction Manual
1. Locking Mechanism 5. Interior Light 9. Security Cable Slot
2. Programming Button 6. Print Reader
3. Battery Compartment 7. LED Night Light Logo
4. Silent Mode Switch 8. Emergency Key Lock
Thank you for purchasing the Magnum Quick Vault. To get started you will need 4 AA Alkaline batteries (not
included), the instructions and the emergency key. The vault has been shipped in the locked position. To install
the batteries and begin programming your new vault please read the entire instruction manual and then
proceed to the "Opening the vault using the emergency key" section below.
Opening the Quick Vault using the emergency key: The Quick Vault is supplied with an emergency key to open
it manually. You will need this key to open the vault so that the batteries may be installed or replaced in the
event of a loss of power or an electrical malfunction. To open the vault using the emergency insert the key into
the “Emergency Key Lock” (9 on diagram). Turn it clockwise or to the right to open the lid. Do not store your
key inside of the vault! The key will override the vaults electronic system allowing you to access the vault at
any time regardless of the battery condition so always store your keys in a secure location. Your emergency
key has a key code printed on the key. Please record your key code below and on the included warranty card.
You will need this number to reorder any lost keys in the future.
__________KEY CODE
To Next Page
Need help?
General
