Strap Mount for Non-vented Helmet / Goggles 3 pcs
Goggles Strap with width below 40mm is compatible!
Just slide your goggles strap into this mount and you
are ready to go. You can use this mount for non-vented
helmet too!
Surf Expansion
Allows quick-release or quickly attached your Bullet HD
on to a surfboard.
Self-portrait Mounting
Allows for positioning of your Bullet HD on the front of
your helmet, so you can self-portrait videos and photos.
Rubber O-ring 6pcs
Remind you to put some silicon grease to the rubber O-
ring from time to time, especially before using
underwater. Make sure the rear cap ③ was closed tight.
Adhesive Mount 8 pcs
Use the adhesive mounts to secure the camcorder with
the Universal Mount included.
Adjustable Silicon Straps 2 pcs
Comes with 2 pieces of flexible & strong adjustable
silicon straps. These silicon straps can be joint
together and allow you to mount to any non-vented
helmet.
To Next Page
Loading...