Bunn Axiom Series Technical Training

Bunn-O-Matic Corporation
5
Electrical Install
Anelectricianmustprovideelectricalserviceasspeciedinconformancewithalllocal,state,andfederalelectrical
codes.
Step 1: Plug the unit into the power source.
Initial Start-Up
Step 1. Insert an empty funnel into the funnel rails.
Step 2. Place an empty server under the funnel.
Step 3. Connect the brewer to the power source.
Step 4. Turn master on/off switch to the on position, located on the side or rear of the machine if equipped.
Step5.PressandreleasetheBrewOn/OffSwitch.Waterwillowintothetankandstopwhenthetankislledtoits
 capacity.Displaywillshow“PLEASEWAIT...TANKFILLING”untiltankislledwithwater.
Step 6. Wait approximately twenty minutes for the water in the tank to heat to the proper temperature. Display will
show “READY TO BREW...WATER TEMP: 200°” when tank is at operating temperature. Some water
will drip from the funnel during this time; this is due to expansion and should not occur thereafter.
Step 7. Place a small container beneath the faucet and open the faucet handle. Release it when you hear the tank
 relling.
Step8.Watervolumesandowsettingshavebeenpresetatthefactory.RefertoadjustmentsfortheSetBrew
Ounces section of this manual should the volume need to be increased or decreased.
Step 9. The brewer is now ready for user setup.
Step 10. Repeat steps 5-9 for remaining side on Twins.
-1000 213.8 101.0 200 93.3
-500 212.9 100.5 200 93.3
0 212.0 100.0 200 93.3
500 211.1 99.5 200 93.3
1000 210.2 99.0 200 93.3
1500 209.3 98.5 200 93.3
2000 208.4 98.0 200 93.3
2500 207.4 97.4 200 93.3
3000 206.5 96.9 199 92.8
3500 205.6 96.4 198 92.2
4000 204.7 95.9 197 91.7
4500 203.8 95.4 196 91.1
5000 202.9 94.9 195 90.6
5500 201.9 94.4 195 90.6
6000 201.0 93.9 194 90.0
6500 200.1 93.4 193 89.4
7000 199.2 92.9 192 88.9
7500 198.3 92.4 191 88.3
8000 197.4 91.9 190 87.8
8500 196.5 91.4 189 87.2
9000 195.5 90.8 188 86.7
9500 194.6 90.3 187 86.1
10000 193.7 89.8 186 85.6
Brew water temperature is factory set at 200 °F (93.3°C)
Areas of high altitude will require lowering this temper
a
ture to prevent boiling. This chart should be used as a
guide when readjusting the brew water temperature.
Altitude
(Feet)
Boiling point
of water
F C
Recommended
water temperature
F C
Brew water temperature is factory set at 200°F (93.3°C).
Areas of high altitude will require lowering this temperature
to prevent boiling. This chart should be used as a guide when
re-adjusting the brew water temperature.

Bunn Axiom Series Specifications

General

Power	Varies by model (e.g., 1800-3000 watts)
Dimensions	14.5 x 9.5 x 11.5 inches
Weight	Varies by model
Features	Digital display, programmable settings, energy-saving mode, automatic warmer shut-off
Category	Coffee Maker
Model	Axiom Series
Capacity	10 cups
Voltage	120V
Material	Stainless steel