Bunn Crescendo - Password Protection

19
PASSWORD 1
1. To enter PASSWORD 1: Open the door and place the NORMAL/
PROGRAM/RINSE switch in the PROGRAM position.
2. In the PROGRAMMING MENU the ENTER PASSWORD 1 screen
will display after the APPLICATION/SW VERSION 00.## screen
(refer to PROGRAM MENU flow chart).
3. The unit is shipped from the factory with a default password setting
of 0000.
4. To set PASSWORD 1: The SET PASSWORD 1 screen will display
near the end of the LOCKS/DISABLES menu. Use the (-) and (+)
buttons to set any numerical password desired, from 0000 to 9999.
Password is set one digit at a time.
NORMAL
PRGM
RINSE
OPERATING CONTROLS AND INTERFACE
In the PROGRAMMING MENU, there are two levels of password protection available:
PASSWORD PROTECTION
PASSWORD 1 Protects all program menu settings.
PASSWORD 2 Allows monitoring and changes to the tank
temperature and strength adjust settings, but
protects all other settings.
PASSWORD 2
1. To enter PASSWORD 2: Open the door and place the NORMAL/
PROGRAM/RINSE switch in the PROGRAM position.
2. In the PROGRAMMING MENU the ENTER PASSWORD 2
screen will display after the STRENGTH ADJUST menu (refer to
PROGRAM MENU flow chart).
3. The unit is shipped from the factory with a default password setting
of 0000.
4. To set PASSWORD 2: The SET PASSWORD 2 screen will display
near the end of the LOCKS/DISABLES menu (refer to PROGRAM
MENU flow chart). Use the (-) and (+) buttons to set any numerical
password desired, from 0000 to 9999. Password is set one digit at
a time.
1. SELECT SIZE
SET PASSWORD 1
(-) 0000 (+)
Use to enter or set the password.
NORMAL
PRGM
RINSE
1. SELECT SIZE
SET PASSWORD 2
(-) 0000 (+)
Use to enter or set the password.