25
The following instructions will guide you through the steps for installing the switch graphics.
• Power off the machine and
unplug.
• Open the front door.
• Remove the 9 screws that
secure the panel to the back of
the door.
STEP 1
• Remove the panel from the
door.
STEP 2
• Remove the screws that secure
the holding bracket to door.
STEP 3
• Carefully remove the control
board from the door assembly.
STEP 5
• Remove the switch graphics
from the door.
• Replace with new switch
graphics.
• Place the control board back in
the door assembly.
• Reassemble the holding bracket
and panel to the door.
STEP 6
Tools Required:
• Phillips Screwdriver
• Remove the holding bracket.
STEP 4
OPERATING CONTROLS AND INTERFACE
Changing The Switch Graphics - to be performed by qualified service personnel only!
To Next Page
Loading...
