Bunn Crescendo - Menu Glossary

30
(-) EXIT (+)
TANK TEMP ###
Set soluble tank temperature.
(-) EXIT (+)
READY TEMP ###
Set soluble tank ready temperature Tank temp. must reach this to enable
brewing if brew lockout is set.
(-) EXIT (+)
ESPRSO TEMP ###
Set espresso tank temperature.
(-) EXIT (+)
ESPRSO READY ###
Set espresso tank ready temperature Tank temp. must reach this to enable
brewing if brew lockout is set.
EXIT YES
CALIBRATION
Takes you to the CALIBARATION sub-menu.
EXIT YES
SET ESPRSO SHOTS
Takes you to the SET ESPRESSO SHOTS sub-menu to set up espresso shots.
EXIT YES
LOCKS/DISABLES
Takes you to the LOCK/DISABLES sub-menu.
(-) EXIT (+)
DIAGNOSTICS
Takes you to the DIAGONOSTICS menu to test components.
NO YES
FACTORY DEFAULTS
Takes you to the FACTORY DEFAULTS sub-menu to enable restoring factory
defaults.
(-) ## (+)
LEFT HOPPER STR
Use +/- buttons to increase or decrease powder hopper speed This menu
repeats for middle and right hopper.
PRESS DISPENSE
TEST LEFT HOPPER
Pressing any dispense button will run hopper for 10 seconds, at speed set in menu
above. This allows a catch test.
(-) #.# sec (+)
SM ESP GRIND TIME
Pressing any dispense button will run grinder for the small espresso programmed
time. This allows a catch test. Menu repeats for large espresso grind time.
DISPENSE TO TEST
TEST SM GRIND
Pressing any dispense button will run grinder for the small espresso programmed
time. This allows a catch test. Menu repeats for large espresso grind time.
ENG EXIT METRIC
SELECT UNITS
Allows applicable data be displayed in English or Metric units.
MENU GLOSSARY
continued >