Bunn Crescendo - Electrical Hook-Up and Calibration

8
OPERATING CONTROLS AND INTERFACE
CREATING A “CUSTOM” BEVERAGE
A “CUSTOM” beverage may be edited/created for any dispense switch location. It is recommended that the
touch switch graphic insert be replaced with one which matches the beverage reassignments made in this
mode. All settings can be adjusted to preference.
• Set the toggle switch to
PROGRAM MODE.
STEP 1
• Advance to the SET ESPRESSO
SHOTS screen.
STEP 2
• Press SELECT.
STEP 3
Use to Navigate
PROGRAM MODE
PRESS TO ENTER
1. SELECT SIZE
Use to Select
SET ESPRSO SHOTS
EXIT YES
1. SELECT SIZE
• Sets the grinder run time for a
small spresso shot.
• Navigate to the next setting.
STEP 4
Use to
Navigate
Use to
decrease
Use to
increase
SM ESP GRIND TIME
(-) #.# sec (+)
1. SELECT SIZE
• Sets the espresso pump run
time for pre-infusion of tamped
coffee. Zero seconds for no
pre-infusion.
• Navigate to the next setting.
STEP 6
Use to
Navigate
Use to
decrease
Use to
increase
NORMAL
PRGM
RINSE
►
Set Espresso Shots
The sub-menus for adjusting an espresso shot are located under this option.
• Sets the dwell time for a
small espresso.
• Navigate to the next setting.
STEP 7
Use to
Navigate
Use to
decrease
Use to
increase
SM DWELL TIME
(-) #.# sec (+)
1. SELECT SIZE
• Sets the total brew volume for
a small espresso shot. The
numeric value is flow ticks.
• Navigate to the next setting.
STEP 8
Use to
Navigate
Use to
decrease
Use to
increase
• The settings will repeat for the
large espresso shot.
STEP 9
Use to
decrease
Use to
increase
LG ESP GRIND TIME
(-) #.# sec (+)
1. SELECT SIZE
Use to
Navigate
1. SELECT SIZE
SM BREW VOLUME
(-) 95 (+)
continued >
• Press a dispense switch to
perform a catch test for a grind.
• Navigate to the next setting.
STEP 5
Use to
Navigate
1. SELECT SIZE
TEST SM GRIND TM
PRESS DISPENSE
SM PREINFUSION
1. SELECT SIZE
(-) #.# sec (+)