Bunn DUAL - Brewer Service Introduction and Component Access; Service Safety Warning; Component Access for Service

Page 14
SERVICE (cont.)
CIRCUIT BREAKERS
CAU
TIO
N
DISC
ARD DECANTER
IF
:
.
C
RA
CK
ED
.
SCR
ATCHED
.
B
OIL
ED D
RY
.
H
EA
TED
WHEN E
M
PTY
.
U
SE
D ON
H
IGH
FL
A
M
E
.
O
R
E
X
PO
S
ED
ELEC
T
RIC
ELEM
ENTS
F
AILUR
E T
O CO
MPLY RISKS I
NJURY
PN:
658
19
8
5 BUNN-O
-
MATIC
CO
RP
ORA
TIO
N
FUNNEL CO
NTE
NTS
ARE HOT
!
!
CA
U
TI
ON
HOT WA
TER
Location
The circuit breakers are located on the lower front
of the brewer, mounted on the server platform just
above the spring contact receptacle assembly.
Test Procedures:
1. Disconnect the dispenser from the power
source.
2. Remove the wires from the circuit breaker.
3. Check for continuity between the terminals. Con-
tinuity must be present between the terminals.
If continuity is present as described the circuit breaker
is functioning properly.
If continuity is not present as described, press reset
button and repeat step #3, if continuity is not present
as described, replace the circuit breaker.
FIG.5CIRCUITBREAKERS
(SH Brewers only)
P1361
FIG.6CIRCUITBREAKERTERMINALS
P1330
BLU/BLKtoTransformer#12
BLU/BLKtoRectier"AC"
Removal and Replacement:
1. Remove the wires from the circuit breaker.
2. Compress the clips on the back side of the server
platform and gently push the circuit breaker through
the opening in the server platform.
3. Push the new circuit breaker into the opening in the
server platform until the clips snap into position.
4. Reconnect the wires to the circuit breaker.
5. Refer to Fig. 6 when reconnecting the wires.
41976 031709