Page 19
P782
DISPENSE VALVE (cont.)
SERVICE (cont.)
FIG. 12 DISPENSE VALVE TERMINALS
WHI/VIO to Right Timer TL1
WHI/VIO to Right ON/OFF Switch
WHI/RED to Right Brew Selector Switch
WHI/GRN to Right Timer TL4
WHI/GRN to Right By-Pass Valve
LEFT on DUAL Brewers
WHI/RED to Left Timer TL1
WHI/RED to Left Brew Selector Switch
WHI/RED to Left ON/OFF Switch
WHI/BRN to Left Timer TL4
WHI/GRN to Left By-Pass Valve
SINGLE Brewers & RIGHT on DUAL Brewers
If voltage is present as described in steps 2 & 4 pro-
ceed to #6.
If voltage is not present as described, refer to the Wiring
Diagrams and check brewer wiring harness.
6. Check for continuity across the dispense valve coil
terminals.
If continuity is present as described, reconnect the
wires to the dispense valve and proceed to #7
If continuity is not present as described, replace the
dispense valve.
7. Check the dispense valve for coil action. Connect
the brewer to power source. Place the ON/OFF"
switch in the "ON" position, press and release the
start switch. Listen carefully in the vicinity of the
dispense valve for a "clicking" sound as the coil
magnet attracts and repels the plunger.
8. Disconnect the brewer from the power source.
If the sound is heard as described, there may be a
blockage in the dispense valve or the water line to the
dispense valve. Remove the dispense valve and inspect
for wear, and remove waterborne particles.
If the sound is not heard as described, replace the
dispense valve.
Removal and Replacement:
1. Disconnect wires and water tubes from dispense
valve.
2. Drain enough water from the tank so the dispense
valves are above the water line.
3. Remove dispense valve from the sprayhead
panel.
4. Install new dispense valve.
5. Reconnect the water lines and the wires to the
dispense valve.
6. Refer to Fig. 12 when reconnecting wires.
41976 031709
To Next Page
Loading...
