Bunn DUAL - Relay Service Procedures; Relay Location and Type; Electro;Mechanical Relay Test Procedures; Electronic Relay Test Procedures

Page 34
P799
FIG. 37 SOLENOID VALVE TERMINALS
WHI to Level Control Board T3 (120V, 120/208V or
120/240V Eletro/mechanical)
WHI to Terminal Block (120/208V or 120/240V
Electronic)
RED to Level Control Board T3 (200 or 240V Electro/
mechanical or Control Assy T4 Electronic)
VIO to Level Control Board T1 (Electro/
mechanical)
WHI/BLU to Control Assy #1 (Electronic)
SERVICE (cont.)
#10-32 slotted head screws holding the solenoid
valve to the mounting bracket.
7. Securely install the new solenoid valve to its
mounting bracket.
8. DUAL BREWERS: Attach the solenoid valve and
mounting bracket to the brewer trunk.
9. Securely fasten the water lines to and from the
solenoid valve.
10. Refer to Fig. 37 when reconnecting the wires.
41976 031709