Page 13
read 2 BATCHES DONE?
8. If both batch sizes are not correct press and release NO to return to the BREW OZ setup screen and repeat
steps #8, 9 and 10.
9. If both batch sizes are correct, press YES. This will advance to the DILUTE OZ.
10. Using (-) or (+), set the amount of dilution water for that particular batch size to be dispensed through the
dilution nozzle into the dispenser.
11. When finished, press the other batch size and repeat step #10.
12. When finished setting both batch sizes, press and release DONE. The display should read 2 BATCHES DONE?
13. If both batch sizes are not correct, select NO to return to the DILUTE OZ function and repeat steps #10-12.
14. If both batch sizes are correct, press YES. This will advance to the DILUTE DELAY function.
15. Press and release YES. The display should now read DILUTE DELAY: and a batch light will be blinking. Press
and release the batch size to be modified.
16. Using (-) or (+), set the time delay for the dilution water to start for that particular batch size.
17. When finished, press the other batch size and repeat step # 16.
18. When finished setting both batch sizes, press and release DONE. The display should read 2 BATCHES DONE?
19. If both batch sizes are not correct, press and release NO to return to the DILUTE DELAY setup screen and
repeat steps 16 - 18.
20. If both batch sizes are correct, press YES. The display should now read SET PULSE BREW.
21. To set PULSE BREW press YES. The display should now read SELECT METHOD. To set the EASY method,
continue to step # 22. To set by MANUAL method, jump to step # 28.
Setting Pulse Brew – EASY Pulse Brew
Range: Minimum: will adjust to the minimum time required to brew that batch using the set brew volumes and
flow rate for the sprayhead. Maximum – will adjust depending on settings and will always be minimum time +
3 minutes. The brewer will automatically calculate what the 1ST ON TIME, OFF TIMES, and LAST ON TIME will
be using THE INITIAL ON TIME, plus a 7 pulse routine.
22. Select EASY. With EASY flashing, select NEXT.
23. The display should now read BREW TIME: and a batch light will be blinking. Select the batch size to be modi-
fied.
24. Using (-) or (+), set the total brew time desired including spray times and off times.
25. When finished, press the other batch size and repeat step # 24.
26. When finished setting both batch sizes, press DONE. The display will show the pulse settings to accommodate
the brew time entered. Press and release each batch size to display the settings for that batch. After a delay,
the display should read 2 BATCHES DONE?
27. If both batch sizes are not correct, press NO to return to the BREW TIME setup screen and repeat steps 24-
26.
Setting Pulse Brew/PreInfusion – MANUAL
28. Select MANUAL. With MANUAL flashing, select NEXT.
29. The display should now read, 1
st
ON TIME and a batch light will be blinking. Select the batch size to be modi-
fied.
30. Using (-) or (+), adjust the 1
ST
ON TIME.
31. When finished, press the other batch size and repeat step # 30.
NOTE: To disable pulse brew, set 1
ST
ON TIME to OFF. Brewer will automatically pulse on tea recipes with a brew
volume greater than 86.0 oz.
32. When finished setting both batch sizes, press DONE.
33. The display should now read OFF TIME. Adjust the OFF TIME using (-) or (+).
PROGRAMMING (cont.)
48497.2 111017
To Next Page
Loading...
