Bunn Titan Dual - SETTING DISPLAY LANGUAGE

Page 16
This function allows the operator to select the language used for the display.
Procedure for setting Language:
1. Press and hold the right hidden button until the display reads SET LANGUAGE? and release.
2. Press YES to proceed. The display should now read ENGLISH. Using (-) and (+), scroll through the available
languages until the desired language is shown on the display.
3. When finished, press SELECT. If the language selected is different from the current settings,the display will
read CHANGE LANGUAGE? ARE YOU SURE? and then will change to CHANGE LANGUAGE? To convert the
display to the new language, press YES. To retain the current language, press NO.
4. The display should now read UNITS. To exit programming and return to the MAIN SCREEN, press and release
either ON/OFF button.
The functions in the second level of programming allow the operator to adjust brew settings and other feature
options.
To access the level 2 function screens press and hold the right hidden button for approximately 5 seconds.
Release when the display reads:
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET LANGUAGE
UNITS
METRIC DONE ENG
SET LANGUAGE?
NO YES
ENGLISH
(-) SELECT (+)
ESPANOL
(-) SELECCIONE (+)
Scrolls through all
available languages
in memory
38112.1 04210540119 071107