4. Adjust the center position of the
tire so that the positions on both
sides are the same.
1. Install handlebar riser
6. Install the lights and fenders,
8. Install the fender bracket screws 9. Take out the pedal with the letters
“R” and “L”, align it with the crank
hole and lock it with a wrench
3. Install the front fork on the front
wheel bearing
5. Tighten the left and right nuts as
shown
2. Adjust the nut position
7. Connect the light wires (note that
the arrows at both ends of the
wiring correspond)
2
To Next Page
Loading...