11
15
Gently, and with diligent care, place the
dresser in its final position, and attach the
anti-tip cables to their counterparts on the
wall, following the instructions from Step 2.
16
Next, you’ll assemble the drawers. Gather
a drawer front, left and right drawer sides,
a drawer back, and a drawer base. Place a
drawer front face down on your work surface
(so the stickers are facing up), attach the
right side of the drawer by lining up the green
(A) stickers, making sure the groove at the
bottom creates a continual line between the
front and side.
Important tip: The clips on the drawers are
permanent and cannot be undone once
clicked into place. Please carefully follow
these instructions.
Tip: If your oors are just a hair uneven, you
can unscrew each leg a little bit to raise that
section of the dresser to compensate.
To Next Page
Loading...