15
23
Once that’s in place, lower the front of the
drawer onto the track. Here, there are two
pins: one gray and one orange. The gray pin
will fit into the bottom edge of the drawer.
The orange pin fits into the inside edge of
the drawer, horizontally, and is engaged by
switching the orange tabs outward. You
should feel a satisfying click once they’re
in place.
24
Repeat steps 21 through 23 for all remaining
drawers, working from bottom to top. If
the drawer isn’t shutting fully, or seems
misaligned, make sure all connection pins/
inserts between the drawer and the tracks are
complete. Then, you’re all set! Time to Marie
Kondo your closet and start using your new
Prospect Dresser. Be sure to tag @burrow on
Instagram and use the hashtag #myburrow to
share your setup with us.
Tip: If the drawers seem uneven, rotate the
circle-shaped tab at the end of the drawer
sliders to raise or lower the height of each
side. Push the tab in to lower, pull it toward
the front to raise.
To Next Page
Loading...
