5
3
Take a back wall panel, and lean it against
the wall as close to the final position of your
dresser as possible. Flip to the last page of
this booklet, use the printed ruler to measure
above the holes on the back wall panel and
4
Screw one leg onto each of the leg plates
in a clockwise direction. If you’re building a
15-drawer dresser, you’ll put together one
extra set of support legs.
make a mark where each screw will go. Then,
hammer in the wall claw anchors at each of
the marks, and use the wall claw screws to
attach brackets to the wall.
__
__
__
__
__
__
To Next Page
Loading...