9
11
Attach the right wall to the right base panel
by lining up the green (A) stickers, with the
“Top A” sticker at the top. There are six clips:
three on the edge of the base panel, and
three on the edge of the wall. Align these
clips, and press them together until you hear
a click. If you have a 9-drawer configuration,
you will need to attach the second interior
wall between the remaining two base panels,
in a similar manner to Step 9.
12
Make sure one person holds the unsupported
walls in place. The other person can attach
the support panel to the right and interior
walls, and between the two interior walls
on a 9-drawer configuration, matching up
the yellow (B) and green (A) stickers. There
are two holes on the support panels; those
should be at the top. Push in the direction of
the arrows on the support panel.
To Next Page
Loading...