9
Power supply / Battery change
A series of beeps indicates that the battery is weak and must be replaced.
• Only use 9V ALKALINE batteries with this lock
• Burton Safes recommend the Duracell brand
To change the battery, you will need to open the safe and remove the
plate on the back of the door with a small screwdriver.
Press the catch on the top edge of the battery
cover with a screwdriver and lever off the battery
lid. Pull the battery out carefully until the battery
clip is visable. Release the battery from the clip
and replace. When the new battery is in place,
re-engage the lid.
Please ensure that the cable is not damaged.
Emergency power supply
• If the safe has run out of power hold a 9V
Duracell battery to the front of the
lock against the + and - connectors
• While keeping contact at all times
with the battery, press the [ON] key
• Enter a valid 6-digit code followed
by the [ENTER] key
• Within 4 seconds, turn the handle
clockwise until the stop position is reached
• Once inside the safe, follow the above instructions
to change the battery
To Next Page
Loading...