buschbeck KINGRANGE - Wine Cooler Operation and Maintenance; Controls and Temperature Settings; Care, Maintenance, and Power Failure

54
OPERATING YOUR WINE COOLER
lt is recommended you install the appliance in a place where the ambient temperature is between 2 °C and 43°C.
If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be aected. For example, ope
-
rating your unit in extreme cold or hat conditions may cause interior temperatures to uctuate. Your Wine Cooler is designed to operate within a
range of 2°C to 18°C.
Hinweis: Die Temperatur °C kann um +/- 2°C variieren.
1 2 3 4 5 6
°C
+–
°F
°C
°F
TASTE FUNKTION
POWER
When the appliance is plugged in the unit will automatically turn on. When unplugged, the
unit will automatically turn o.
1 Display
The display panel on the left of the control panel shows the current working temperature. The
temperature range is 2-18°C (36-64°F). The temperature will rise gradually to the set value
after working. And it will get up and down by ±2 dierence.
2 °C/°F DISPLAY When a temperature unit is chosen, the corresponding display will illuminate.
3 INCREASE Press to increase the temperature.
4 DECREASE Press to decrease the temperature.
5 LIGHT Press to turn the LED lights on or o.
6 °C/°F Press the °Cj°F button to select between units of temperature measurement.
Function CELSIUS FAHRENHEIT
Red winw 14,4 - 18,3°C
58 - 65°F
Rosé and
Sparkling wines
4,4 - 8,3°C
40 - 47°F
Dry white wines 8,9 - 13,9°C
48 - 57°F
Rosé wine 9,4 - 10,6°C
49 - 51°F
RECOMMENDED TEMPERATURE SETTINGS CARE AND MAINTENANCE
IN CASE OF POWER FAILURE
Most power cuts are resolved within a few hours and should not aect
the temperature ofyour appliance, provided if you limit the number of
times the door is opened. If the power is o for a langer time, please
take steps to protect the contents.
NOTE: If the unit is unplugged, power is lost, or it is turned o, you must
wait 3 to 5 minutes before restarting the unit. The unit contains com
-
pressor protection which will prevent the unit from starting until this
time period has elapsed.
When you use the wine cooler for the rst time or restart the wine cooler
after having been shut o for a lang time, there could be a few degrees
variance between the temperature you select and the one indicated on
the LED readout. This is normal and once the wine cooler is running for
a few hours the display will be correct.
CLEANING YOUR WINE COOLER
Turn o the power, unplug the appliance, and remove all items inclu
-
ding shelves
Wash the inside surfaces with warm water and a soft cloth
Wash the shelves with a mild detergent solution
Wring excess water out of the sponge or cloth when cleaning area of
the controls, or any electrical parts
as_Kingrange_de_en_fr_it_revI.indd 54as_Kingrange_de_en_fr_it_revI.indd 54 09.01.24 10:5109.01.24 10:51