HDTH 8 Finish Mower 09/20
Assembly Section 3-7
© 2020 Alamo Group Inc.
ASSEMBLY
ASSEMBLY
LIFT PINS
Lift Pins 3 Pt Lift (Figure 3-5)
1. Install the Lift Arms into the pockets at the front of the machine. Install the category I & II lift pin in the front hole
in the lift arms and secure with the Lynch Pin.
2. Insert a 1” x 2-3/4” Clevis Pin into the front hole of the pocket and the middle hole of the Lift Arm. Fasten with
the Presto Pins from the Bag of Parts
Lynch Pin
Category I & II
Lift Pin
Category I & II
Lift Arm
Figure 3-5
1” x 2-3/4”
Clevis Pin
Presto Pin
The 3-Point Hitch System on this mower has been designed for front to back
flotation when mowing on uneven terrain. The tractor lift arms should be
set such that the mower 3-Point lift arms are parallel to the ground in floating
position.
To Next Page
Loading...
