Installing your gas hob
Bringing it all together
Installing your gas hob
21
or online at www.bush-support.com If you still require further assistance, call one of our experts on 345 257 7271.
• During installation, please ensure that isolated
cables are used. An incorrect connection could
damage your appliance. If the mains cable is
damaged and needs to be replaced this should be
done by a qualified personnel.
• Do not use adaptors, multiple sockets and/or
extension leads.
• The supply cord should be kept away from hot
parts of the appliance and must not be bent or
compressed. Otherwise the cord may be damaged,
causing a short circuit.
• If the appliance is not connected to the mains with
a plug, a all-pole disconnector switch (with at least
3 mm contact spacing) must be used in order to
meet the safety regulations.
• The fused switch must be easily accessible once the
appliance has been installed.
• Ensure all connections are adequately tightened.
• Fix the supply cable in the cable clamp and then
close the cover.
• The terminal box connection is placed on the
terminal box.
Brown
Yellow+Green
Blue
To Next Page
Loading...
