Care and maintenance
Looking after your appliance
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Never use any sharp instruments or abrasive
substances, soap, household cleaner, detergent
or wax polish for cleaning.
Use luke warm water to clean the cabinet of the
appliance and wipe it dry.
Never clean the applia s.
It could cause damag
re hazard.
Clean the exterior of the appliance and door seal
with a damp cloth and dry it through.
Avoid water going into the temperature control box.
Clean with a dry cloth only.
Clean the condenser (located at the back of the
appliance) with a vacuum cleaner. It is suggested
to remove the dust every year.
Shelves are all removable for cleaning purpose.
The interior of the refrigerator should be cleaned
regularly to avoid odor.
Check the door gasket regularly to make sure
there are no debris.
ower before cleaning,
remove all food, shelves, drawers, etc.
Clean the door gasket with mild soap and water.
Do not rinse with water so as not to a ect the
Do not use soap, detergent, scrub powder, spray
cleaner, etc., as these may cause odors in
theinterior of the refrigerator.
Wipe the outer surface of the refrigerator with a
etc., and then wipe dry.
Do not use hard brushes, clean steel balls, wire
brushes, abrasives, such as toothpastes,organic
solvents (such as alcohol, acetone, banana oil, etc.),
boiling water, acid or alkalineitems clean
refrigerator considering that this may damage
the fridge surface and interior.
For areas that ar to clean in the
refrigerator (such as narrow sandwiches, gaps
or corners),it is recommended to wipe them
necessary, combined with some auxiliary tools
refrigerator,with two tablespoons of baking soda
and a quart of warm water. Then rinse with water
and wipe clean, and open the door and dry it
naturally before the power is turned on.
Dusts behind the refrigerator and on the ground
e ect and energy saving.
To Next Page
Loading...
