DOOR T-LATCH
The T latch is located inside the crisper tub. The T latch must be used when the fridge is installed in anything
mobile like a caravan, boat or RV.
1. There are 2 screws already affixed in the front of the fridge cabinet, in between the freezer and fridge
doors, on the opposite side to the hinges. Each screw has a small plastic cover which you can pry off.
2. Remove the 2 screws.
3. Position the T latch on the fridge and insert the 2 screws. Fasten the screws only finger tight.
4. Check that the freezer and fridge doors close without hitting the main arm of the T latch. Move the T
latch into a good position.
5. Tighten the 2 screws.
OPERATING THE FRIDGE
THERMOSTAT SETTING
• The cooling level can be set between 1 and 7. (7 is the coldest setting and 1 is the warmest)
• We recommend starting the thermostat on 3 and let the fridge run for 2 – 3 days. Only turn the
thermostat up from there if the fridge is not reaching 4˚C. Always use the lowest number possible.
• Do not use setting 7.
EQUALISING THE FRIDGE
During the first 24 hours of operation, your compressor will operate for longer than usual. This process allows
the internal air temperature, food, drinks, condenser and insulation to equalise.
ENERGY SAVING TIPS
• Have a much ventilation as possible – the more the better.
• Keep the fridge out of direct sunlight whenever possible
• Only open the fridge or freezer door when necessary
• Allow hot food to cool down before placing inside the fridge
• Defrost the fridge as soon as a thick (10mm) layer of ice forms
• Set the fridge to be only as cold as necessary
CLEANING
Wash the inside of your fridge with warm water and a mild soap. Never use abrasive or corrosive cleaning
agents, steel wool or scouring sponges. A soft sponge, towel, or soft brush is recommended.
Always keep the inside of the fridge clean and dry. Keep the doors of the fridge ajar when the fridge is not in
use, to allow fresh air to circulate inside the fridge compartment.
To Next Page
Loading...
