Need help?Do you have a question about the BWD minilab and is the answer not in the manual?
General| Detector | Silicon Photodiode |
|---|---|
| Type | Spectrophotometer |
| Data Output | USB |
| Measurement Range | 0-200%T |
| Power Supply | AC 50/60Hz |
Detailed specifications for waveform generation, frequency range, output levels, and modulation.
Explanation of controls for the function generator, pulse, amplitude, and ramp generators.
Description of controls for the power amplifier, bi-polar supply, and voltage/operational amplifier.
Details on controls for variable and fixed power supplies, and AC source.
Instructions for operating the function generator, including waveform selection and output adjustment.
Guidance on connecting loads and using the power amplifier with input signals.
Instructions for operating the bi-polar and +5V fixed power supplies.
Steps for using the voltage and operational amplifier functions.
How to set and use the ±15V variable regulated power supplies.
Instructions for operating the 0 to 200V variable power supply.
Detailed explanation of the circuit generating triangle and square waveforms.
Steps for aligning the +15V and -15V fixed power supplies.
Alignment steps for maximum frequency, minimum frequency, and symmetry.
Adjustments for minimizing switching transients and setting output frequency.
Procedures for setting 1.0MHz and 0.1MHz output frequencies.
Steps to adjust the output amplifier for zero DC offset.
Alignment for buffer amplifier offset and amplitude modulator.
To Next Page