Set-Up Before Use
Telescopic pole (not included) assembly (only for EU & USA)
Press down the side pins of the telescopic pole connector and insert it inside the main
body. Turn the connector in either direction until the pin is secured in the hole, as shown
in the diagram.
Slide the telescopic pole onto the pole connector. Press on the side pins of the connector
and slide the telescopic pole further down until the pins of the connector are secured
inside the holes of the pole.
To release the telescopic pole, press down the side pins simultaneously and pull out the
pole.
Specific Telescopic pole (not included) assembly(only for Australia & New Zealand)
Insert the end (with two side pins) of the specific telescopic pole connector into the pool
vacuum as shown until its side pins are secured to the pole connector’s locking hole on
the rear body. To install the specific telescopic pole (with internal wishbone clip) to the
pole connector as shown:
To Next Page
Loading...
Need help?
General
