2
bwt.com
English
P500 / P600 Robotic Pool Cleaner
System overview
The robotic cleaner sweeps the pool floor and walls collecting dirt
and debris in its internal filters. This user manual explains how to
operate the robotic cleaner, including cleaning, maintenance and
storage procedures. Note: This manual reviews several different
models with variations.
Robotic cleaner operation
After the robotic cleaner is placed in the pool and activated, it
operates according to its program. It moves along the floor and
walls of the pool, covering the entire area of the pool. When it has
finished its program, it remains inactive on the pool floor. Power will
automatically shut off. Note: It's not recommended to stop the pool
cleaner prior cycle end.
Note: Wall climbing is an optional feature. When the wall climbing
feature is enabled, the robotic cleaner climbs the wall at intervals
according to its internal program. Its ability to climb over stairs in
swimming pool is subject to stair geometry and material.
Operating conditions
The robotic cleaner is intended for use in residential swimming
pools only in the following conditions: (1) Recommended water
temperature 22°C-32°C (72°F-90°F). (2) Water pH : 7.2 - 7.6
(3) Chlorine level: pool is maintained according to the pool
manufacturer’s instructions. (Recommended Chlorine level:
2-4 ppm) Note: Failure to maintain the pool according to the
recommended operating conditions could prevent the robotic
cleaner from functioning properly.
Introduction
Trolley
Power
supply
Power
cable
Robotic
pool
cleaner
Components
To Next Page
Loading...
