CAUTION
●
To prevent damaging the
transmission, press the "P"
button only after the vehicle has
completely stopped.
●
"R": Reverse, used only when the
vehicle has come to a complete stop.
●
"N": Neutral, used for temporary stop.
●
Under all circumstances, always shift
to "P" before the driver gets out.
●
"D": Drive. Shift to "D" to drive the
vehicle normally.
●
Turn the ignition on before shifting
into "D".
●
Shifting out of "P" or into "D" gear
requires pressing the brake pedal and
the UNLOCK button at the same time.
For details, see the prompt message on
the instrument cluster.
●
If the shift is successful, the lever
returns to its middle position after it is
released.
WARNING
●
Transmission may be seriously
damaged due to lack of
lubrication if the vehicle is
allowed to move for too long after
the motor is turned o and "N"
gear is engaged.
WARNING
●
When the motor is running and
the vehicle is in the "R"/"D"
gear, always stop the vehicle by
stepping on the brake pedal, as
there is still force transmitted
from the actuator and the vehicle
can travel slowly even in its idle
condition.
●
If you want to shift a gear while
driving forward, do not step on
the accelerator pedal to prevent
accidents.
●
Never set the shift lever to "R"
or press the "P" button while the
vehicle is in motion to prevent
accidents.
●
It is not recommended to allow
the vehicle to go down a ramp
when it is in the "N" or "P" gear,
even if the vehicle is not started.
●
To prevent unintended vehicle
movement, pull up the brake and
press the "P" button once the
vehicle has stopped completely.
Electronic Parking Brake
(EPB)
EPB Switch
Be sure to engage the EPB every time
before parking and leaving the vehicle.
115
04
USING AND DRIVING
To Next Page
Loading...
