BYD ATTO 3 2023 - Page 158

(turning on the compressor), which
can reduce air󽗊ow moisture.
●
In the ventilation mode, the system
introduces the natural wind from
outside, which is suitable for spring
and autumn.
REMINDER
●
A/C odor:
●
It is normal that there may be
a damp and moldy smell just
after the A/C is turned on. During
the operation of the automobile
A/C, A/C condensation often
remains in the evaporator, and
the wet evaporator can easily
absorb un󽗉ltered body sweat,
smokes, etc., inside the vehicle.
Condensation not blown dry
makes the dark and damp
evaporator surface prone to
mold, which is very likely to
produce unpleasant odors by
long-term fermentation.
●
How to prevent A/C odors:
●
Turn o󽗈 the A/C and ventilate
with natural air before parking
to keep the air inside the vehicle
relatively dry.
●
Inspect, clean, or replace the
󽗉lter regularly.
●
Try to keep the cabin clean and
fresh.
●
If the odor persists after odor
prevention methods are used, it
is recommended to contact a
BYD authorized dealer or service
provider for repair.
●
In order to reduce odors from
the A/C, if the A/C is already
turned on, the A/C blower may
keep running for a while after the
vehicle is powered o󽗈 and locked.
That is because the condensed
REMINDER
water on the surface of the
evaporator needs to be dried to
prevent mold fermentation. It is
normal for the A/C blower to start
running automatically when you
lock the vehicle. No need to worry
about it.
Vents
Front Center Vent
●
Move the knob to adjust air󽗊ow or to
open/close the vent.
●
Toggle left/right to adjust air󽗊ow
direction.
Front Side Vents
●
Move the knob to adjust air󽗊ow or to
open/close the vent.
●
Toggle left/right to adjust air󽗊ow
direction.
157
05
IN-VEHICLE DEVICES