BYD ATTO 3 2023 - Page 23

WARNING
impacted or drive roughly in harsh
road conditions.
●
This vehicle's airbag system has
been fully veri󽗉ed to seamlessly
match the vehicle's original
wiring harness system. Any wiring
harness modi󽗉cation or alteration
may cause the airbags to
deploy mistakenly under normal
conditions or fail to deploy in the
event of a collision.
It is recommended that you contact
a BYD authorized dealer or service
provider immediately if any of the
following situations occurs.
●
The airbag has deployed.
●
Instrument cluster airbag warning light
lights up abnormally.
●
This airbag system is monitored by
the ECU and has a self-diagnosis
function. Its status is displayed by
the airbag warning lights on the
instrument cluster.
●
With the ignition on, if the airbag
warning light stays on for about
󽗉ve seconds and then disappears for
more than 󽗉ve seconds, the system is
running smoothly.
If any of the following events occurs,
the airbag system is faulty. Please
contact a BYD authorized dealer or
service provider immediately.
●
When the ignition is switched on but
the warning light goes o󽗈.
●
When the ignition is switched on but
the warning light does not go o󽗈 after
󽗉ve seconds, or goes o󽗈 and then on
again.
●
When the ignition is switched o󽗈 but
the warning light turns on.
●
This warning light turns on or 󽗊ashes
during driving.
●
There is a collision with the front of the
vehicle (highlighted area shown), but
the front airbags do not deploy.
●
The airbag cover has been scratched,
cracked or otherwise damaged.
●
Airbags need to be removed,
disassembled, installed or repaired.
●
Side airbags and curtain airbags have
deployed.
●
An impact to a vehicle door in an
accident is not adequate to cause the
airbag to deploy.
●
The surface of the seat with a
side airbag is scratched, cracked, or
damaged similarly.
●
Decorative (liner) parts at A-pillar with
built-in curtain airbags, roof beam
and C-pillar are scratched, cracked, or
damaged similarly.
22