Status LED Indicator Beeping
Ignition o or E-Call system
failure
O \
Power-on self-check mode Flashing fast - 2 Hz \
Ignition on and self-check
passed
Solid on if self-check is
passed
\
E-Call connecting Flashing - 1 Hz A beep
E-Call connected Flashing - 1 Hz A beep
E-Call ended Solid on Two beeps after E-Call ends
Callback time (60 minutes by
default)
Flashing extremely slowly -
0.2 Hz
\
Sunroof Switch
Panoramic Sunroof
The sunroof can only be operated when
the vehicle is powered on or when the
power-o delay has not expired.
Opening the sunroof
●
Press and hold the sunroof open
button ① to open the sunroof
manually. Release the button midway
to stop the sunroof at its current
position.
●
If the sunroof has been initialized,
pressing the sunroof open button ①
and release it immediately, the sunroof
tilts up for ventilation. Pressing the
button again will set the sunroof to
open automatically by about 80%.
Touching the button once more will
open the sunroof completely. If button
① or ② is pressed when the sunroof
is opening, the sunroof will stop at its
current position.
Closing the sunroof
●
Press and hold the button ② to close
the sunroof. The sunroof will stop if the
button is released.
●
If the sunroof has been initialized,
releasing the sunroof close button ②
immediately after touching it closes
the sunroof automatically. For the
sunroof to stop at its current position,
press the ① or ② button midway.
Opening/Closing Sunshade
Opening the sunshade
●
Press and hold the sunshade open
button ① to open the sunshade
manually. Release the button midway
to stop the sunshade.
77
03
CONTROLLER OPERATION
To Next Page
Loading...
